Fujitsu Tablet Accessory FMWSP6 User Manual

FMWSP6 Screen Protector

Installation Instructions

3. Install the screen protector. Apply the adhesive

side to the screen with the notch in the lower left

corner. Apply pressure along the edge of the

screen protector with your finger. (Avoid lifting

the screen protector from the screen after it is

installed. The adhesive requires 48 hours to cure.)

Stylistic 2300

The FMWSP6 screen protector can be installed on

the Stylistic 2300 pen tablet display screen or on the

display window of the FMWCC30 harsh

environment case. Note the following:

• Before installing a new screen protector, remove

any screen protector that is already installed. (A

notch in the corner of the screen protector allows

you to slide your fingernail or a sharp

implement under the screen protector for

removal.)

• To ensure good adhesion, clean the display

screen with a soft cotton cloth dampened with

denatured alcohol before installing the screen

protector.

4. Remove the protective film from top of the screen

protector.

1. For installation on the Harsh Environment Case

only: Remove edge from screen protector.

2. Peel protective film from adhesive side of screen

protector.

5. Clean the exposed surface of the screen protector

with a soft cotton cloth dampened with denatured

alcohol to remove any adhesive left behind by the

protective film.

Stylistic 2300 is a trademark of Fujitsu Personal Systems, Inc.

9/98

58-0601-00A